Is there an instrument driver for Heraeus Vötsch Test Chamber VMT 07/35?

[MLindberg]

Hi Dave,

I have attached the pages from the Operations Manual about the connections to the chamber.

Hope that will help you.

/Martin

[Dave_B]

Thanks alot Martin!  This was what I needed.  Now I just need to hope that my pinout is the same on my chamber.

[K C]

Hi,

In the manual I have (also another type of chamber) the same pinout is used.

[SimoneFilippin]

I have problems with VT4010, i have the manual but i'm not sure about the commands, eg        $00I<cr>     --> read chamber, but i get not response, i'm sure that the configuration is OK...... 

I'm trying to communicate through Labview, by using serial interface RS232 and ASCII strings.

[GGT]

When I get back to work next week I'll post my latest Heraeus VIs.  These control both the older and the new oven controllers.  They might work for you. Even if they don't they might give you some clues as to getting yours going.

Regards, GGT.

[SimoneFilippin]

Hello all,

I had problems with VT 4010, the problem was only that in the user manual was not write the wiring of RS232  25Pin to 9Pin.

The wiring is the following:

25Pin  -->  9Pin

2 --->  2

3--->   3

7--->  7      (NOT 2 with 3 and viceversa).

[appala]

Hi All

I am trying to control VT 7004 through LabVIEW

As the first step we made DB9-DB25 adapter as in the attached DB9-DB25 Adapter diagram

After that we tried with the heraeus VI's given in this topic, it seems no communication is going with chamber

i have few doubts 

1) is the DB9-DB25 cable i made as shown in the fig is correct?

2) In the VI it is mentioned that we have to press "EXT" switch on the chamber for remote control from PC

 could i use these configure, setconstant and tempdwell VI's for  VT 7004

Thanks

Pradeep

[appala]

Hi Cencio86, All

I have doubt in 9PIN to 25 PIN connector

9PIN          25PIN

2        --->   2

3        --->   3

5        --->   7

am i correct?

Is the vi's given in this thread worked for VT4010, i want to use these for VT7004

Thanks

Pradeep

Message Edited by appala on 03-31-2009 03:39 AM

[BobSpearing]

KC - Any chance you could scan the basic operating instructions for the  Heraeus Votsch HC 4030 Humidity chamber ?

Cheers

Bob

[K C]

Hi Bob,

No problem but I at this moment I am sitting at home on the couch (gout)

As soon as I get back to work I will look into it.