Reset clock to zero upon start save

[helend]

Hi,

I would like to reset my clock to zero upon commencement of the save of the measurement values., i.e. I need the first measured value to correspond to t=0s.   Is it possible to do this by connecting my start block to the reset input of the system clock? This brings up error messages.  Unfortunately the installation I am currently using does not allow me to carry out any measurements (simulated or otherwise).

Thanks,

Hel

[Walter_Rick]

Hi Helend,

If you have a trigger which indicates when to create a new time channel starting with zero you can simply use the stop input of the save block. The parameters to set in the save block are:
Trigger: retrigger able
Data storage: With section creation -> Parameters: Use new channels for every measurement.

Attached you find a small example.

Greetings
Walter

[helend]

Thanks Rick,

I'm not sure how to apply this for my block diagram, which looks like the one attatched.  My system clock begins when I start the measurement but I want it to reset when the button "Startspeicher" is clicked.

Hope you can help,

Helen

[Walter_Rick]

Hi Helend,

What do you think about the attacheched example?

Viele Grüße

Walter