NI Roach Clip

[becktho]

TiTou: It found its way to Liechtenstein - so obviously it also should find its way to Geneva (if I remeber correctly).

[Dennis_Knutson]

I got mine too!

[TiTou]

You remember well becktho
I've double-checked my address in my NI profil... Now I can only wait.

[AnalogKid2DigitalMan]

I tried mine out as a soldering aid also, but the smoke kept gettin in the way and I made a lot of cold joints and then I had a case of the munchies...and forgot that... oh yeah, that I left my iron on since last night. Now I have to get a new tip, what the flux?

With a little patience, you can use it to hold the foamy star from last year upright.

Message Edited by AnalogKid2DigitalMan on 01-23-2007 08:39 AM

[shoneill]

Titou,

I can vouch for the ability for the roach clip to bypass swiss customs.

I got mine last week.

Far out.

Shane.

[tbob]

AnalogKid....  You've been watching too many Cheech n Chong movies...

[AnalogKid2DigitalMan]

tbob:

Yeah, that circuit I built last night went "Up in Smoke" when I powered it up, but at least I had "Nice Dreams"

At least in LabVIEW all you have to watch for is the broken arrow.

[RayFarmer]

You were surpose to remove the roach clip from your circuit board before applying power

[AnalogKid2DigitalMan]

Hey Ray, thanks for reminding me where I left it .

[Dennis_Knutson]

---

@AnalogKid2DigitalMan wrote:

tbob:

Yeah, that circuit I built last night went "Up in Smoke" when I powered it up, but at least I had "Nice Dreams"

At least in LabVIEW all you have to watch for is the broken arrow.

---

Kid, are you sure you didn't get this as the gift?