How to programm the EH 1504 pulse generator?

[Criss1]

I am using an old pulse generator EH 1504 but, unfortunately, I do not have a documentation about the programming part. It has a GPIB card, also produced by EH. Can you please instruct me how to programm it, or, alternatively, do you happen to have a manual for this particular pulse generator? Thank you very much.

Message Edited by Criss1 on 03-20-2007 06:17 AM

[Richard_KEROMEN]

Hello,

The first thing you must do is installing the NI-488.2 drivers for GPIB communication wether you use NI products. Then the use of GPIB is well-known, you can use common commands (internet :" common GPIB commands") but if you need more specific commands i suggest you get in touch with your hardware dealer and ask for the documentation, that's the best thing to do.

Hope this helped...

Regards,