module enable

[krupa]

In my code,i have enabled the mods before using them as the 1st step but even after this implementation i find the 4th LED(Red) on the module(9505) turned ON when i run the code.

Not only that,by enabling this mod,the motor connected to it is expected to run but it ain't.

Pls help me out.

[rle2]

Can you show the whole code?

First thing you need to make sure you connector the 12V-36V DC power supply to Vsud (C,V).  To run the motor, you need to drive true value to "Motor"

[krupa]

Pls find the screenshot attached.

I have given True to motor and the power supply is properly connected.

I am able to read chassis temperature from this i understand that i am able to read from the mod but not able to send signal.

[rle2]

Sorry for late response - NI forum was updating. Anyway, can you try something this simple?