12-29-2010 03:59 PM
I can use the NI 9236 in full bridge sensors?
Solved! Go to Solution.
01-07-2011 11:02 AM
Good afternoon Andres,
Yes, the link that is the information from NI 9236 module and page 12 is below:
http://digital.ni.com/manuals.nsf/websearch/B6D4FACAAF870CD2862572AB00604824
Sincerely,
Mauro Vera.
01-07-2011 04:44 PM - edited 01-07-2011 04:44 PM
On page 12 I have this diagram. Please explain how I could connect my load cell is full bridge 4 wires. thanks for the information
01-10-2011 06:50 AM
Good morning,
Sorry, this module is only 1 / 4 bridge, the bridge is not complete.
This used to be the NI USB-9237 information on page 11 and 12 on the link below:
http://www.ni.com/pdf/manuals/372306b.pdf
Sincerely,
Mauro Vera.
01-10-2011 08:35 AM
In conclusion, Not is posible conect 1/4 bridge module.. full bridge load cell. Is it Correct????
01-10-2011 09:49 AM
Yes.
01-10-2011 10:01 AM
Thanks....
02-12-2018 07:16 AM
I am trying to use a Honeywell tje pressure sensor part number 060-0718-18tjg with NI 9236, by the documentation it should work / I think. What am I doing wrong?
exc - pin A
rc - pin c
ai - pin d
02-13-2018 11:23 AM - edited 02-13-2018 11:24 AM
Hola Tiaaero,
Gracias por utilizar los foros de National Instruments, te recomiendo abrir un nuevo foro describiendo tu duda, ya que este foro ya fue resuelto y ya no se le está dando seguimiento.
Si abres un nuevo foro hablándonos sobre tu proyecto, podremos apoyarte específicamente con tus dudas. Además, te recomiendo compartir archivos como fotos, códigos, hojas de especificaciones, etc. para que toda la comunidad tengamos más información y te apoyemos a solucionar la situación lo más rápido posible.
Te envío saludos.
02-16-2018 10:11 AM
I'm trying to run full-bridge strain gauges with the NI-9236; here you say it can be done? Could you please provide some insight on how to wire that?