I'm a systems administrator setting up computers for an RF training environment and I have a question related to the installation order, if necessary. I've read about installing LabView older programs first, then drivers, etc.
Below are the following items I was tasked with installing. Based on what I have to install, is there any set order to the items? NOTE: This is for an air-gapped system (intranet only).
Thank you.
I have the following to install-
NI-488.2 (v.19.5)
NI-VISA (v.19.5)
NI CompactRIO (v.20.5)
NI R Series Multifuntion RIO 20.0
NI DAQmx (v.20.1)
NI Industrial Commmunications for EtherCAT (v.20.0)
