Benchtop Measurement and Test
Distributed Measurement and Control
High-Performance Test
Systems Engineering Software
Perspectives showcases how NI sees what’s next in the world of test and technology.
You can request repair, RMA, schedule calibration, or get technical support. A valid service agreement may be required.
Provides support for NI data acquisition and signal conditioning devices.
Provides support for Ethernet, GPIB, serial, USB, and other types of instruments.
Provides support for NI GPIB controllers and NI embedded controllers with GPIB ports.
From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
在 01-04-2019 06:21 AM
在讀取數據(加速度規的data)時,發現以高取樣頻率去讀data時,訊號會在開始的時候被shift一個值,隨著降低取樣頻率,shift值也會逐漸減小。請問這樣是正常的嗎?還是哪裡有問題?
在 01-07-2019 01:32 AM
您好,
請問你用的卡片是哪一個?缐是怎樣的連接方式?
在 01-07-2019 03:35 AM
您好:
使用的卡片是PCI-6229,加速度規是插到SCXI-1531上。
請問您問的線的連接方式,是指哪裡的線?
在 01-08-2019 12:17 AM
這頻率的訊號來源的 input是多少?然後關於平移值是有預定要取得什麽值嗎?是否已經知道會取得什麽讀取值?
在 01-12-2019 01:57 AM
主要量測的是加速度計的加速度,且加速度計當時是靜止擺放的,因此照理來說不管取樣頻率設多少,加速度要接近於0才對,且不應該會出現加速度值平移的現象。
在 01-13-2019 11:47 PM
請問曾經有做過類似的實驗嗎?目前看來是有接近於0,應該算是正常的。如果之前使用不會出現這種情況,那有可能是硬體的問題,或是加速度計的問題。
在 01-14-2019 07:49 PM
您好
之前的實驗也是都有這種情形,請問根據取樣頻率設定不同,會產生誤差是正常的嗎?
在 01-14-2019 10:37 PM
一般來説,會有一點點誤差,但不會相差太大。可以到NI Max的self calibration測試,然後在Test Panel再測試看輸出的結果,如果值一樣偏離0太多,像第二張圖-0.15,就是不正常了。
What do you need our team of experts to assist you with?
Thanks!
We'll be in touch soon!