Hello,
I would like to run an executable command to open MATLAB and the on-screen keyboard when I run my program. I found teh system exec.vi and am able to open MATLAB, but not the keyboard. The error message I get is
Error 3 occurred at System Exec.vi. Command was ""C:\%SystemRoot%\system32\osk.exe""
Possible reason(s):
LabVIEW: Internal error. Wrong memory zone accessed.
---
NI-488: GPIB Controller not addressed correctly.
I had added the C:\, so I think that was wrong. But when I deleted that part and had my command as what I found in teh properties I got teh following errors.
Start in: %HOMEDRIVE%%HOMEPATH% (From properties)
Error 2 occurred at System Exec.vi. Command was ""%HOMEDRIVE%%HOMEPATH%""
Possible reason(s):
LabVIEW: Memory is full.
Target: %SystemRoot%\system32\osk.exe (from properties)
Error 2 occurred at System Exec.vi. Command was ""%SystemRoot%\system32\osk.exe""
Possible reason(s):
LabVIEW: Memory is full.
I am not familiar with execution from within a program, so I could be missing something. Am I? Is there anything I could read to get a better understanding?
Thank-you!
IBAHKA
ps- I will attach my vi if it may help.
