Simulate input

[ChristophePo]

Hi,

  To verify my software, I would like to simulate some signals on the input of the NIDAQmx simulated board. Is it possible ?

  I have created the simulated board in NI MAX, but I does not know how to simulate signal on the inputs and run my software (in C langage) to acquire the data.

Thanks

[WM_John_Weeks]

When I have made simulated devices, doing a scan of analog inputs gets you data in the form of a noisy sine wave. I can't recall what happens if you read digital inputs.

Outputs don't do much 🙂

[stockson · Accepted solution]

The input signal of a simulated device is predefined, you cannot change it. It is much better to write your own piece of code that would simulate the signal.

[ChristophePo]

Ok thanks !

[crossrulz]

But while you are here, go give this idea a Kudos: Interactive DaqMx simulation interface