DAQ: error 10041

[alain]

I use a DAQ card to measure a voltage, and my program works. But when I create an application of my program (xxxxx.exe), there is an error: "error 10041, The specified task ID is invalid. For instance, you may have connected a taskID from an Analog Input VI to a Digital I/O VI."
Do you know what i'm supposed to do?

[Dr._Imad]

in your LV  program, you may be setting some channels / devices without making them defaults. It will probably work.  But when you create the application, the original value (the default) is used.

[Kerouac]

Hello,

To make current values default in your front panel controls, open your VI and then go to the Menu "Operate >> Make Current Values Default". Save your VI and rebuild your executable with the application builder. It should work now. Do not forget to install NI-DAQ on all the target PCs where your executable will be installed.

Hope this helps.

Matthieu G.