DAQ 6008

[Brendanbyron]

when i go to configure an Analogue Input for example on the DAQ it comes up "No products Supported"

I had this working yesterday but now nothing,

I re-installed all the software to see was it the software but the same thing comes up.

I tried to re-install the DAQ Software but this comes up as " Fatal Error, Unable to create temporary file " and wont let me install this.

what should i do

thanks

B

[Tom.]

Hello,

The error messages you are experiencing are similar to those described in this KnowledgeBase article. Are the ones you've written in your post Verbatim?

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000PA1jSAG&l=en-US

If this article doesn't help you then post back here.

Good Luck

Tom.
NIUK

[tdoodnau]

Hello,

I am getting the same problem when I try to do an analog input with the no products supported.

I have read the article

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000PA1jSAG&l=en-US

and i have confirmed that

1. I have installed daqmx base 2.1.0f0 and daqmx driver version 8.3.0f3, running labview 8.0

2. The device appears in MAX under usb devices and also in device manager under NI-VISA USB Devices as NI USB-6008 Multifunction IO

I have ran the DAQ diagnostic utility 2.0 and it does not detect the device there either.  I am also using powered usb ports.

Any Ideas?

Thanks,

[Tom.]

Hello,

Take a look at this - [broken link removed] This may help you, it discusses the issues faced when using both DAQmx and DAQmxBase within LabVIEW with USB Devices.

Hope this helps!

Tom.
NIUK