ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

Home Community Discussion Forums Most Active Hardware Boards Multifunction DAQ Topic

Multifunction DAQ

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Calibrating a load cell

Calibrating a load cell

‎09-28-2018 04:24 AM

Hey guys.

Just looking for a good procedure to calibrate a load cell in Lab View. I have my load cell wired up and reading input in the VI module, but I don't have the calibration certificate. Just wondering if there is a good workflow, or procedure to follow. I have access to a instrumented load frame which i can use to apply know loads.

Cheers,

https://downloader.vip/rufus/ https://downloader.vip/mapquest/ https://downloader.vip/uptodate/
0 Kudos
Message 1 of 2
(2,336 Views)
Reply

Re: Calibrating a load cell

‎10-09-2018 08:33 AM

A free standard is

https://www.ptb.de/cms/fileadmin/internet/dienstleistungen/dkd/Allgemein/DKD-R_3-3_2018.pdf

 

however it's in German language, so may a translator can help.

 

 

Greetings from Germany
Henrik

LV since v3.1

“ground” is a convenient fantasy

'˙˙˙˙uıɐƃɐ lɐıp puɐ °06 ǝuoɥd ɹnoʎ uɹnʇ ǝsɐǝld 'ʎɹɐuıƃɐɯı sı pǝlɐıp ǝʌɐɥ noʎ ɹǝqɯnu ǝɥʇ'


0 Kudos
Message 2 of 2
(2,281 Views)
Reply