Hi
I have a problem getting a encoder signal into a labview program. The encoder is connected to a UMI 7764 motion device. This device is connected to a PC trough a PCI 7330. I heard rumors that I can't have more than two axis on a PCI 7330. But can I have more than 2 encoders on it?
The big problem is that I am new to the motion system and I don't know where to begin.
I'm going to finish a uncompleted system, but when I look at the VI, I get nervous. So you are my last hope.
I have taken screen captures of the VI and uploaded it.
My task is to implement a new encoder signal to the already-made VI.
Question is:
How do I add and read out a RPM signal from a new encoder?
VI download:
http://www.mediafire.com/?k1ckbozeppffv1z
Best regards
Henrik Myhre
