How to implement direct communication between two singleRio boards by using Ethernet?

[yuefeiw]

Now in my project we choose 2 SingleRio-9032s as our controllers. We need the two controller can be exchanged data directly by using Ethrenet ?How can I do ?

[Drew_T · Accepted solution]

yuefiew,

This discussion probably belongs in the LabVIEW RT forum.

However, I would suggest looking into LabVIEW Shared Variables.  The two links below will give you more information on the topic:

https://www.ni.com/en/support/documentation/supplemental/06/using-the-labview-shared-variable.html

http://zone.ni.com/devzone/cda/tut/p/id/9900 

Kind Regards,

[yuefeiw]

OK,thanks a lot . Net published shared variable may be a good choice. But I am not sure the delay caused by this method can meet our requirement.My sampling time is 50us. I will ask for help in Labview RT. thank you for your guidance.

Yuefei

[Drew_T]

Yuefei,

The following link is a good guide on finding a networking protocol to suit your needs.

https://www.ni.com/en/shop/labview/using-the-right-networking-protocol.html

See you over in the RT forums!