tdms channels and groups names

[mectronik]

Hi ,

past 30 october 2008 , We signaled a problem with and group names . Mr. NESTOR GOMES ( from National Instruments ) open the following issue :

"The corrective action request (CAR) was filed to R&D with ID #126102"

The problem is that if I create TDMS files from Diadem ( We have last versione 11 , but problem is the same with older version ) , the Names of Channels and Groups are not readed from inside .NET application .

I checked every release , bu tthis problem is still present , do You have any informations about this issue ?

Thank

MARCO CORTECCHIA

Mectronik srl

[lucius]

Hi,

the problem has been solved with the introduction of version 2.0 of tdms;

as you can read here the new format is now supported by Labview 2009 and Diadem 11.1.

The future release of Measurement Studio will include support for TDMS 2009, in the meanwhile there is a Stand Alone installer which allows to read (not write) the new format in the previous versions.

Best regards,

Lucius

[drohacek]

Measurement Studio 2009, now available on ni.com/mstudio, includes full support for TDMS 2.0.

David Rohacek

National Instruments