vision_acquisition

[ToloV]

Hi,

I use LabView 2011 on Windows7 machine, I have installed Vision Acquisition Software correctly in my machine, and when I open a project I recibe a Error list with IMAQdx....vi errors. I tryed to reinstall and reapir Vision and the problem continues happening. The project works ok in other machine with the same LabView version. Can anyone help me with this?

Thaks.

[udka]

Hi ToloV,
Looks like problem with installing vision acquisition module. In the block diagram, please check in the Vision-> IMAQdx->do you've vis like IMAQdx Grab,snap??
If not, try reinstalling vision acquisition module and don't forget to install the driver dvd also.

[GuenterMueller]

Did you verify in the Release Notes (screenshot below) that the version of the Vision Acquisition Software supports LabVIEW 2011?

Which version of VAS do you install?

[GuenterMueller]

Sorry for my misrelated screenshot in the previous mail:  The Release Notes will just tell you the minimum version of LabVIEW that will be supported.  All current versions of the VAS support LabVIEW 2011.  So the only chance I see that you don't get IMAQdx support in LabVIEW 2011 is installing a version of the VAS that is too old.

[Klemen]

Hello,

you need to install the NI IMAQdx device drivers (device drivers dvd).

Best regards,
K