Setting the IMAQ attribute

[GcDago]

I was used to adjust the white and black voltage levels (0 to 1.26V) of the NI-1407 to optimize the input signal range of the acquired image.

Now I've installed the NI-1405 and the attributes are different. In particular I can adjust the White level (0.3 to1.26), the Contrast (0.4 to 1.5),

the Brightness (-50 to +50) and the Saturation (0.5 to 1.5). Moreover I see that there is also the possibility to set parameters like the balance of the Red, Green, Blue (gain).

In which way could I adjust the attributes of the NI-1405 to have the same effect of adjusting the white and black levels of the NI-1407?

Thanks a lot

Giancarlo

[Chuck_81]

Hi Giancarlo,

sorry for the very late reply. Take a look to the following docunment:

Black Reference Voltage Level of the PCI-1405 and NI-1411

Hope this helps,

Fabio