Simple frequency acquisition

[cdb931]

Hello,

I'm trying to acquire a sine wave from my com1 via rs232. I don't have a DAQ, and that's where it's causing problems. I have a sine wave of around 200 hz going through an rs 232 cable into my computer. The frequency will shift between 0 and 200 hz. I pretty much have tried looking everywhere but all of the solutions seem more complicated than they should be. I'm using LabVIEW 8.2.1.
I will upload my VI so you can see. In the end, I want to replace the "simulate sine wave" with the acutal sine wave coming from the RS232. It's an analog sine wave.

[jr_2005]

You have posted your question on the LabWindows board; there are a lot more LabView specialists on the LabView board, so I suggest you post your question there instead. Good luck...

JR