LabView PID control with PWM output and Ramp/Soak.

[dh2o]

I have LabView 8.5 and a CompacDaq with 9263, 9205, 9472 and 9211 modules.

 I need to build a test fixture that will control two heaters.

 I want a LabView program to have PID controls and PWM outputs.

The PWMs will turn on/off solid state relays to control the heaters.

The program will also need ramp and soak so I can heat and cool the device under test slowly.

Any suggestions?

[RobertoBozzolo · Accepted solution]

Please repost this question to the LabVIEW forum