From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
03-12-2010 03:30 AM
Hi
Can some one please help.
I wrote a programe which reads and writes to a device using devicenet .
How do you read and write to multi nodes using devicenet ?
Thanks.
Solved! Go to Solution.
03-15-2010 01:03 AM
03-15-2010 10:05 AM
Hi Shako,
The best way to get started with using multi node communication is probably by checking out the EasyIOMultipleDevice.vi example in the example finder. It is located in the Hardware Input and Output >> DeviceNet folder, as shown below.
I hope that helps, let us know if you have any further questions.
Thanks
Scott M.
03-16-2010 06:57 AM
Thanks for the help.
I found in the documentation that when you call for an event you get the mac id and other information needed for multinodes.
12-02-2011 02:06 PM
This is not what is in my example folder. there are only two projects which aren't working. How do i find these examples? I am using LabVIEW 2010, have installed a PCI 8532 DeviceNet Board and wish to communicate with an MKS mass flow controller.
thanks,
chaz
12-02-2011 03:09 PM
Hi chaz,
If you are using LabVIEW, you should post to the LabVIEW forum - this one is intended for CVI 😉