vertical scroll bar

[praky]

hi,i am new to LabVIEW..so i have small doubt.

In LabVIEW 7.1 have a Table with vertical scroll bars. i take output of measurements in table.  When the table is  full, the vertical scroll bar starts to move "up" the table. Is there a way to keep the srcoll bar at the bottom, so that the last line is always visible?

[BenjaminR]

Hi,

On this post you have your answer http://forums.ni.com/ni/board/message?board.id=170&message.id=154507&requireLogin=False

[Vsh]

here too

http://forums.ni.com/ni/board/message?board.id=170&message.id=310294&jump=true

[Wayne.C]

You can create a property node  Property>Index Values that controls the upper left cell displayed in the table. 

Subtract the # of rows displayed in the front panel from the # of rows in the table to figure out which row value to write.  You can use property node Property>Number of Rows to determine how many rows in table.   

Ooops.  I'm a bit slow typing today. 

Message Edited by centerbolt on 03-20-2008 11:39 AM

[praky]

thank you for all your responses...  benjaminR, vsh, centerbolt