sbRIO CLIP generator with LabVIEW FPGA 2024

[LorAlc]

Hi.

I'm using LabVIEW FPGA 2024 Q1 and LabVIEW 2024 Q3 64bit.

I can create the CLIP with the sbRIO CLIP generator but when i try to load it on the project, this error apperas:

Searching on the forum, i found this discussion: https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000YR7CCAW&l=it-IT.

I do the settings shown in this page but they seam not working for me.

Is it a known problem or is it a problem only for me?

Thanks.