saving software trigger in project

[ben64]

I created a project with Signal Express v3.0 where I use software trigger to start and stop acquisition. When I close signal express and then reopen the project the software triggers do not show up in the bar below the menus.

Is there a way to keep the software triggers in the bar when we close the project and signal express?

Thanks,

Ben

[RavensFan]

I would suggest posting in the Signal Express forum.  While some LabVIEW users have probably used Signal Express, I bet most have not.  While anyone in the Signal Express Forum have probably used it and would be in a better position to help.

[ben64]

Thanks, it was my intention to post it to the Signal Express board but I obviously did something wrong. Thanks for pointing it.

Ben

[mishkin]

Duplicate post on Signal Express forum here