robotics

[benchia_17]

Hi,

I have a DaNI Robotics Starter Kit. Attached is a Router and an IP Camera.

Basically, I would like to save an image onto my computer. This image is captured by the IP Camera and sent wirelessly by the router to the computer. I can see the image on the front panel as the router acts as a "wire" connection to the Single Board RIO. However, I have no idea on how to save the image.

If anyone could help, it would be very appreciated.

Cheers,

Ben

[Hornless.Rhino]

If you're using IMAQ to do it all then have a look at

http://zone.ni.com/reference/en-XX/help/370281P-01/imaqvision/imaq_write_file_2/

[RedAG]

Try this link http://forums.ni.com/t5/LabVIEW/Community-nugget-Code-Capture-Tool-2-0/m-p/1034265#M460545