missing sub vi's

[braider]

Hi. I am looking for the following sub vi's. I am using a 16 channel DAQ board to read analog voltages into Labview. The main VI I'm using was downloaded from NI's examples back in 2004. The PC I used in '04 was thrown out at some point. I am now using the same main VI on a different PC, and I'm missing the following sub VI's. I'm using Microsoft XP and a PCI-MIO-16XE-10 PC card. Where can I find the following VI's?

1. String Column Header.VI

2. Create Data String.VI

3. Multiple Time Delay Match.VI

4. Channel String to Name Array.VI

Thank You,

Braider

[Dennis_Knutson]

They are in examples\daq\solutions\datalog.llb and examples\daq\solutions\transduc.llb on my pc.

[waldemar.hersacher · Accepted solution]

In addition to Dennis you have to install Traditional DAQ to get the examples. I'm not sure if this is selected by default during installation.

[braider]

Thank you both. Is that available on the website or somewhere in my pile of cd's??

[waldemar.hersacher]

It is on the Device Driver CDs/DVD. Start Setup again and look in the product selection dialog. You have to open some of the nodes under Measurement or Data acquisition (don't konw the exact naming).

[Robbob]

If you can't find your cd for Tdaq, we have it on our website at our Drivers and Updates page