ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

mark923

Solved!
Go to solution

mark923

‎06-23-2011 11:06 AM

Using daq, how do I wire a relay on the 9481? I want to turn on one relay.

0 Kudos
Message 1 of 2
(2,543 Views)
Reply
Solution
Accepted by topic author Mark923

Re: mark923

‎06-23-2011 11:51 AM

Hi,

 

I'm not sure if you are asking about the physical wiring or the code wiring.

 

I would start by using Max, testing the On/Off using the test panel, then naming a task for turning on/off that channel. 

 

Then in LabVIEW you can use the DAQmx Drivers to turn that relay on and off, using the task name. ( please tell me you don't plan to use traditional DAQ 🙂

 

This should get you going in the correct direction.

 

-------
Mark Ramsdale
-------
0 Kudos
Message 2 of 2
(2,538 Views)
Reply