labview servo (sg90) parameter problem

[OguzAkseki]

Hello everyone, i am trying to do pid servo motor control on labview. As far as i am concerned, i need to acquire the transfer function of motor but i don't know the parameters of motor. I could not find from its datasheet. I will use sg90 servo motor on my program. How can i obtain the parameters? If you interest and can help a bit, i am glad. 

[mikeporter]

Talking to the motor vendor might give you some insight, but if you want the transfer function for the motor -- and what it's driving, you will need to measure it.

Mike...

[OguzAkseki]

 I will try to look through the angle of motor on my program with pid alghoritm. I will use Arduino Uno for this program. An user will set an angle value what wants,then i will try to bring to specific angle.

[ahmed803]

Hello!OguzAkseki, I need help from you!!

[Frankay]

Hi Ahmed803,

As this thread is about a year old I would recommend you create a new thread with a detailed question for the highest chance of receiving help on the forums!

Best of luck.

--

A. Frank

National Instruments