image animation

[nolsqn]

hiii all

i need to move an object with respect to its roll pitch and yaw data ... i am getting the data from serial port.... and its working fine .. now i need to move any image in labview on basis of these values.... i was able to draw a rectangle in 3D picture ..but i dont know how to make it move as i required....

the object can be anything .... 

[srikrishnaNF]

hi nolsqn,

  Have you used any transformation Vis in 3rd picture control pallette?

Thanks and regards,

srikrishnaNF

[altenbach]

FOr some ideas, have a look at the solarsystem.vi example in the example finder.

[shrekt · Accepted solution]

Hi,

as said above, you can do as below

 just change the values

regards,

[nolsqn]

i have seen the tranformation vi's but was not able to understand them to the point that how to use them. i will have a look at solar system.vi and wil get back at you

thnx

[nolsqn]

HI shret...

can you save the vi u have attached in 8.5 

as i m using this version

regards 

[nolsqn]

hi altenbach

i dont seem to have solarsystem.vi in my examples.... i m using labview 8.5  but its not in my examples

[altenbach]

Search for "3D", then it's the third example from the bottom of the list.

[nolsqn]

i finaly got it to work...

thnx all

[shrekt]

Hi,

below is 8.5 vi