if statement

[rainy01]

Hi everyone!

I'd like to do following statements in Labview.

if a=0.001

then b=0

        c=1

        d=2

        e=3

        f=4

else if a=0.002

then b=5

        c=6

        d=7

        e=8

        f=9

end if

Thanks!

[altenbach]

What should happen if "a" is something else (not 0.001 or 0.002)?

Typically, you would use a case structure. Try it!

Of course you need to be very careful comparing floating point values. Whree does the "a" data come from?

[Ranjeet_Singh]

Hope this is what you are looking for.

Run the VI and change the value of a.

Thanks

[altenbach]

---

Ranjeet_Singh wrote:

Run the VI and change the value of a.

---

(You might want to add a small wait to that loop.)

Here's an alternative version using arrays.

[Ranjeet_Singh]

Sir altenbach,

                           How you changed the controls and indicator. Never saw like this before.

[moderator1983]

---

@Ranjeet_Singh wrote:

                           How you changed the controls and indicator. Never saw like this before.

---

If your create a front panet using 'Silver Controls' (and of course indicators) and downgrade it to any LabVIEW version lower than 2011. You'll see the same.

[Ranjeet_Singh]

friend,

                            Looks like some kind of magic for me. 

Thanks

[altenbach]

Yes, I started out with your code (which was silver style), but downconverted, because the OP did not say what LabVIEW version he has.