error message: no registered trigger lines

[Zexi]

Hi,

I was using the example within labview 7.1 under "Hardware input and output ------Daqmx ------Synchronization------Multi-function---multi-funtion-synch AI-AO.vi". I was using pci-6032e card (device 2) for input and pci-6713 card (device 1) for output.

Then this error message jumped out when I was trying to run the labview vi.

Possible reason(s):

No registered trigger lines could be found between the devices in the route.

If you have a PXI chassis, identify the chassis correctly in MAX, and make sure it has been configured properly. If you are using PCI devices, make sure they are connected with a RTSI cable and that the RTSI cable is registered in MAX. Otherwise, make sure there is an available trigger line on the trigger bus shared between the devices.

Source Device: Dev2
Destination Device: Dev1

Task Name: _unnamedTask<9>

I am using RTSI cables connecting the two devices. But I don't know how to check if this RTSI cable is registered in MAX or not. If not, how could I register it?

Thanks,

Zexi,

[e-Cash-Money]

Hello Zexi,

This discussion forum post explains how to configure the RTSI cable in MAX!

[Zexi]

Thank you for your information.

I just had trouble finding that item RTSI cable in the MAX. Later in the help, I found that I needed to use "creat new" to creat that item. Thanks very much.