create a logger from measure-code

[christian30823]

Hello,

I have a main-code for conductivity measuring. (AnalogDevice- Evaluation CN-0349-Kit)

Its very good and cheap solution for a "conductivity-meter".

I would like the measuring beginn every minute (for example) automaticall and consulution the program should also save the log.

But I do not get get the adjustment.

Its a adjustment a major programming task?

My "solutions"(try) with a simple counter and a puls-generator on the "measure-button" were unsuccessful.

Can someone help me? (with tips/tricks/solutions, or ,or, or)

Best regards

Christian D.

[Bob_Schor]

Oh, my, you are trying to rewrite "Demo Software" provided by a vendor who may or may not know how to write good LabVIEW code, and you want to try to fix it?  And you are not a LabVIEW expert (or, at least, up to CLAD or CLD level)?

You may consider some advice I've been know to give when confronted with undocumented, difficult-to-read code -- "Start Over".  [I do realize this is probably not practical in your case, so here's a different piece of advice -- Find (or Hire) a LabVIEW Guru].

Bob Schor

[christian30823]

Hello Bob...,

thanks for your answer.

I was hopping a "auto-mesure" is easy to implement in this software.

I thought a automaticly start (every minute) is no big deal... but I have already noticed the contary... 😞

I think it's ever good that you say difficult-to-read code...I thought just me was going there.

short info  about the program:

- with this program and corresponding modules can measure conductivity

[christian30823]

I believe its possible without guru-crafts... ;:)

but my experience not enough... 😞

actuate automatic or periodic  the measure-button:

If I select property "Value Signal" that then is the push automatic...or?

I get this only with ERROR-Massage (not wired...)

It should be possible??!! 😕

Can someone help me or try the variant ?

greetings

Christian

[GerdW]

Crosspost in German LabVIEWForum…