Re :NI ELVIS FPGA BOARD

[Bodhisattya]

Hi Suraj

Yes we have tried with both the FPGA board and both the cRIO and all of them are throwing the same error with code difference in case of ELVIS and cRIO thats it. Let me remind you againg that cRIO controller is getting connected with the computer successfully but when i m trying to deploy the chassis(9116) then it was throwring an error and after that the controller it getting disconnected. Please go through the previous attached file to have a look at the complete event. I have taken snap shot of every step I have taken and attached here. 

Thanks 

Bodhisattya Sarkar

Department of Instrumentation and Control

College of Engineering 

[SurajPawar]

Hi, 

 Got that part. I wanted to know if apart from these cRIOs which are throwing an error, if there are any other cRIOs you were able to try with ?

Thanks

Suraj Pawar

AE, NI India

[Bodhisattya]

Hi Suraj,

 No, I didn't have tried with the other cRIO. I have tried with only cRIO 9022 but we have tried two ELVIS FPGA board and both the board are showing the same error.

[SurajPawar]

Hi, 

 Could you then try with other cRIOs ? If they do not exhibit this error, we can immediately conclude that the issue is specific with your hardware and we can RMA it to our office to check here. 

Thanks

Suraj Pawar

AE, NI India

[Bodhisattya]

okay, I will get back to you after checking the other cRIO.

[Bodhisattya]

Hi suraj,

I have checked both the cRIO and both the cRIO are throughing differet problems. It would be of great help if you visit our college and take the cRIO and FPGA board for RMA. We need this cRIO and FPGA board on urgent basis so please kindly take  an action as soon as possible.

Wiht Regards

Bodhisattya Sarkar

Department of Instrumentation and control

College of Engineering Pune 

[Bodhisattya]

Hi suraj,

 Can you please tell me that when it will be possible for you to visit our college to provide the service for cRIO and FPGA board.

Wiht Regards

Bodhisattya Sarkar

Department of Instrumentation and control

College of Engineering Pune 

[kishan.M]

Dear Sir,

Pl help to share us your contact details and email id so that we can discuss in detail and proceed further in resolving the issue.

Regards,

M.Kishan

AE TEAM,

INDIA.

[Bodhisattya]

Contact Details:-

Bodhisattya Sarkar

email id- bodhisattyasarkar@yahoo.com

Mob No.- +91 9957165902

Contact Address:-

Department of Instrumentation and control

Near Data Center

College of Engineering Pune

Wellesely Rd, Shivajinagar,

Pune, Maharashtra 411005

Sir, I request you kindly to please me us solving this issue as soon as possible.

With Reagards

Bodhisattya Sarkar