05-15-2005 03:22 PM
05-15-2005 06:49 PM
@hood1 wrote:
in total cycles variable/control when i write one, it runs once cycle that means all 3 banks/elements and then stop.when i write two,it will execute for two complete times and when i write 3,it will execute 3 complete times and so on so forth. but when i write 0,it must not execute not at all.why even when i write 0,it executes atleast 1 time and then stop?
@hood1 wrote:
in TimeTakenAry when i set 00:00:00 to all three banks.it must not execute at all.why i see some signal on the graph and why i see some execution?
@hood1 wrote:
in the inside while loop i am slowing down the while loop by using the delay of 1000. if i dont use the delay, it will execute very fast and if one element of TimeTakenAry i set to 1 hour.it will not run upto 1 hour and like i said, it finishes very fast.why?what is not correct there?
if i set time 1 hour and i dont use any delay.it must run upto 1hour.why it executes so fast and finishes early? moreover one while loop takes how much time to complete one loop.does it take 1000ms to complete one loop?
05-16-2005 10:35 AM
05-16-2005 11:23 AM
05-16-2005 12:11 PM
05-16-2005 12:24 PM
05-16-2005 09:26 PM
05-17-2005 05:50 AM
05-18-2005 07:04 AM
05-18-2005 05:41 PM