I am rather new to LabView and I am trying to acquire and log data from a Tektronix TDS5054B o-scope using SignalExpress. More specifically, I am running a pulsed experiment, with a rep-rate of roughly 1 min. I am using all four channels and triggering off channel 1. I would simply like the data from all four channels to automatically get saved each time the o-scope is triggered. This is undoubtedly within the capabilities of SignalExpress, but changing the settings on the 'Trigger" tab within 'Step Setup' hasn't yielded the results I am looking for.
I apologize for asking this standard and rudimentary question, but I haven't figured this out through Google and other NI forums. Finally, I have the network, hardware, drivers, etc.. all set up correctly because I have been able to obtain a continuous signal via the instructions found on:
http://zone.ni.com/reference/en-XX/help/371268M-01/expresswb/ivi_example/
Any provided information will likely be useful, esp. step-by-step instructions like the one above.
Thanks.
