04-25-2019 09:20 AM
Trying to Execute reading values on a timed interval and then writing those values into a table.
I have attached our current set up. I am looking to take the Capacitance reading, a "user defined" amount of times over a "user defined" interval of time.
i.e.
1 reading every 10 seconds for 60 seconds
6 readings of Cap total over 1 minute
I have timers in there and I can't for the life of me figure out how to get the value I seem to be gernetaing for Cap to be output anywhere besides where it is currently going.
I hope to have the data readable on screen AND printable to paper but even if it just exports to excel nicely that will work too.
Thank you,
Josh
04-25-2019 09:27 AM
Hi Josh,
1 reading every 10 seconds for 60 seconds
6 readings of Cap total over 1 minute
Easiest solution: use a FOR loop set to iterate 6 times, with a 10000ms wait function inside next to your DAQ code…
I have attached our current set up.
No, you didn't…