Hi All,
I am new to Labview and have been given the following assignment
Create a temperature control system. Temp reaches a high set point (30c) and heater switches off. Temp reaches a low set point (20c) and heater turns on
My problem is getting the case structure to reach the high set point and turn to false (heater off) and stay in false until reaching the low set point
The attached picture is where I am at now. If the temp is below the high set point it will add 0.5 to the temp reading every cycle. once it reaches the set point it will turn to false and subtract 0.5 before turning back to true, thus not allowing it to return to low set point before becoming true again
Hope this makes sense