From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I have an application where I am using a pneumatic air solenoid spool valve to apply force to a load cell in a load cycling application. The signal that controls the process is a 0-1V DC Square wave (frequency and duty cycle are controllable via front panel, typical setup would 0.2 Hz, 50% Duty) I would like to count the number of cycles actually performed. Attached is a snippet of code where I cannot get the Trigger / Gate + Statistics to count the number of triggers (it is behaving the same as the full vi that I created, where a trigger is not occurring)
NOTES:
Using Labview 8.2
I have tried to copy and past the entire Trigger Counter example minus the examples signal generation with no success, the cycler seems to stop working.