I'm trying to write a labview interface to program a KDS 230
(www.kdscientific.com) infusion pump. It communicates via standard
RS232 can I can succesfully give it commands (and make quereys) when
using hyperterminal with the following settings:
BPS: 9600
Data bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Emulation: VT100
Input Translation --> Select Host System Encoding Method: Shift-JIS
ASCII Setup --> Sending --> Line delay: 100ms, Char. Delay: 100ms
--> Receiving --> Append line feeds to incoming line ends
These are the settings that are described in the manual and the
settings on the pump system match these. How can I use labview to send
commands to the pump? I've been trying to use "VISA Write" but to no
avail. Any help wo
uld be appreciated,
Sam Johnson
