LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Sensor Calibration in LabView

Solved!
Go to solution

Hi, I'm having trouble trying to calibrate the SingleTact pressure sensors using myRio / LabVIEW.

I'm new to LabVIEW and getting confused how to design the programme. 

 

My project is to design a low-profile trackpad for finger gesture detection, where I can detect finger contact on a surface of 100 x 100 mm and plot the resultant signal data on the GUI.

 

Any help will be gratefully appreciated.

 

regards,

Nalsis

0 Kudos
Message 1 of 3
(2,239 Views)
Solution
Accepted by topic author nalsis

The first step is sitting down with pencil and paper and writing out the series of steps that your program will be doing.  Make a simple flowchart, or write it out in pseudocode.

0 Kudos
Message 2 of 3
(2,213 Views)

Hi RavensFan,

Thanks for your starting recommendation.

0 Kudos
Message 3 of 3
(2,169 Views)