SIT Exhaustive Examples

[McTALAO]

Hello,

where I can found exaustive examples for SIT.

I've created, from a Simulink model, a DLL that I would use stand alone.

How should I use the following blocks? (see attachment).

Thanks in advance.

Federico (Italy)

[ThSa]

Frederico,

to get basic information enquire the Simulation Interface Toolkit help.

You can find the help in your LabVIEW development environment by browsing to the following point:

Help -> Search the LabVIEW Help... -> Browse in the contents tree to Toolkits -> Simulation Interface Toolkit.

I recommend to start with the How-To. After that move on to Simulation Interface VIs -> Model Interface VIs and User Interface VIs

Thanks,

ThSa

Message Edited by ThSa on 10-28-2008 12:37 PM

[McTALAO]

Hi ThSa,

i reat it and I didn't find examples for my work.

On my PC is not installed Matlab and I want to run the DLL, created with Simulink, in an independent manner.

I created the following VI, which runs the model for 10 seconds (see attachment).

I'm not sure if I made the right VI.

I doesn't know the potential of the blocks because I have not found examples.

Best regards,

Federico.

[Mathan]

quick search

also see here

[Mathan]

collect some info from the pdf in the attached zip

[McTALAO]

Hi Mathan,

I have another question...

I have a DLL compiled with Simulink, where I had specified the step simulation.

Is possible, from the DLL, extrapolate information on the step of the simulation?

Best regards,

Federico.

[Mathan]

It depends on the dll. Am not sure about that. Could you please attach that dll?

[McTALAO]

OK.

The simulation time step is 0,01 sec (Simulink --> FIXED STEP SIZE: 0.01).

Thanks,

Federico.