10-19-2007 12:23 PM
10-19-2007 01:06 PM
10-19-2007 01:15 PM
12-11-2012 11:56 AM
dear friend,i am working on a project where i have a gwinstek GDM-396 multimeter to be conneted to an RS 232 port.
watever voltage is recorded from the multimeter should be trasmitted on a waveform chart in labview. i have written a labview program but i am always getting a 0 output.i have already set the parameters(parity,baud rate...) of the multimeter in the labview also. i am quite new to labview. help me please to get that output voltage in labview.
please find attached my program.i am using labview 7.0.
thanks
12-11-2012 11:56 AM
dear friend,i am working on a project where i have a gwinstek GDM-396 multimeter to be conneted to an RS 232 port.
watever voltage is recorded from the multimeter should be trasmitted on a waveform chart in labview. i have written a labview program but i am always getting a 0 output.i have already set the parameters(parity,baud rate...) of the multimeter in the labview also. i am quite new to labview. help me please to get that output voltage in labview.
please find attached my program.i am using labview 7.0.
thanks
12-11-2012 12:48 PM
You hijacked yet another thread and you did not post any code.
Did you look at the existing Instek drivers to see if they have anything in common with your model?
12-11-2012 10:06 PM
The programming gude can be found under the downloads section. http://www.gwinstek.com/en/product/productdetail.aspx?pid=39&mid=80&id=204
Unless there's a driver for that specific model, I'm going to guess it's probably not going to work. You are just reading back the values of the 7 segment displays.