Putting frontpanels of sub-Vi's togeter on one Vi front panel

[JoVMo]

Hi guys,

How to put the frontpanels of my sub-Vi's to one Vi frontpanel? So they are collected at one panel.

[Omar_II]

It called a Sub Panel

[JoVMo]

Tnx Omar, And how to use this sub panel?. How I get in a frontpanel from a sub Vi?

[TiTou]

In LabVIEW, go to Help >> Find Example... and search for subpanel.

In LabVIEW, go to Help >> Find Example... and search for subpanel.

In LabVIEW, go to Help >> Find Example... and search for subpanel.

In LabVIEW, go to Help >> Find Example... and search for subpanel.

Examples are otfen a good source.

[TiTou]

I don't know how comes the first line was duplicated a few times... not intentional.

[TiTou]

I don't know how comes the first line was duplicated a few times... not intentional.

[NitzZ]

@TiTou : I wish my kudos get duplicated like your posts.. LOL..

[_Faust]

See an example; I use the 'load and run.vi', I think you have it or it is available somewhere.

If the subvi is in the same dir as the calling VI, you can use this code.

The position property node is for changing the positition in the subpanel.

The code is a bit sloppy but I hope you get the point

[DFGray]

Awhile back, I wrote a short tutorial, with example code, on how to use subpanels.  You can get it here.

[JoVMo]

Tnx, good advice here, I will look into it....