From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Plc Program for Pass Fail Signal From Labview

Plc Program for Pass Fail Signal From Labview

‎06-15-2019 12:02 PM

Labels:

HI Experts

  I am New For PLC and Labview. I Have a Yokogawa WT310 Power Standby Instrument and Delta DVP SV2 Plc Its supported for rs 232 my Question is When I Get the Pass and Fail In labview I want to Take That signals To Plc by RS232 Communication Can i know how to write the Program

Conditions:

1. When Labview Shows Pass Signal The gate has to open.

2. When Labview Shows Fails Results The gate Should Not open 

 Could You Any Body Help to Write the Program In Delta Plc program for Above Conditions

 

0 Kudos
Message 1 of 1
(1,751 Views)
Reply