Labview and CANoe Standalone Manager interface

[teju_18]

Hello,

I want to send data from LAbVIEW to a Vector device. I do not have CANoe installed on my PC instead I have Vector Standalone Manager for CANoe.

Is it possible to send data from LabVIEW to Vector device through CANoe Standalone Manager and read it back?

[gregorelectric]

Hello,

unfortunately i could not find any information on this. Maybe you can check the following post:

http://forums.ni.com/t5/LabVIEW/from-CANoe-to-LabVIEW/m-p/2736215

[teju_18]

Hi,

Firstly thank you for your help. But I have already seen that link and its not very useful in this case. I will try to get some help from Vector support.

Thank you.

[Hooovahh]

Did you see this library?

https://decibel.ni.com/content/docs/DOC-30180

I use it to write/read CAN and LIN from CANcaseXL.

[teju_18]

Hi,

Unfortunately there are no free CANoe Dlls available on vector website 😞

[Hooovahh]

Why do you need to use CANoe to send and receive data through a vector device? You haven't described the problem enough.

[TroyK]

---

teju_18 wrote: Unfortunately there are no free CANoe Dlls available on vector website 😞

---

There are no free CANoe dlls on the Vector website but there is a free driver library that you can use to talk directly to the hardware bypassing the need for a CANoe license altogether.

See this NI community document here: Vector XL Driver - LabVIEW wrappers

Failing that, doesn't CANoe install with an ActiveX inteface?