Labview, ActiveX and Multisim

[Dimon87]

I create the vi in Labview to communicate with Multisim throw ActiveX (Word file below )

Where I should set the circuit name?
What are input and output names?
And what should I do else?

Thank You All!

[Dimon87]

Here the vi in LV 8.5

[GerdW]

continue here

[Ray.R]

Thanks Gerd, but it's probably better to continue where it was mostly discussed, here:

http://forums.ni.com/ni/board/message?board.id=170&message.id=324425#M324425

Which was probably a new thread after you posts... 😞