LabVIEW FPGA

[fpgalabview]

Hello to all,

I am studying on FPGA and DMA transfer.
I would like to create square wave from FPGA.vi and show it on Host.vi
For this, I created attached vi diagrams. I have problems on signal correctness.
According to the problem, I attached the signal results on 250k frequency and 10M frequency.
My electronic device is sbRIO9606.

Where is the error? And, how should I correct my error?
Please, help me find it out.
Thank you.

[fpgalabview]

A small help can be very good, please 

[Hooovahh]

Your subject title is "LabVIEW FPGA" which is not very descriptive.  You posted pictures of your code, not the actual code.  And you waited only 2 hours before bumping the thread adding no new information, these are all examples of bad etiquette.  (Unofficial Guidelines)

Did you search the example finder?  Because if you go to Help >> Example Finder, and search FPGA Wave you'll find there is a Square Wave example.  Your frequency seems a bit high, at lower frequences does it work properly?  Do you have a scope to see if the output is correct?  Do you have a frequency generator to see if the input is correct?