LabVIEW 2013 SP1 Quit LabVIEW

[KurzVero]

Mr. Eidloth,

Would it be possible for you to send me the Build-Folder you generated including the GUIDemo.exe?

Thank you very much.

Regards.

[Heinrich-Hans]

Hello Ms. Kurz, I forgot, for this PC we used a image of another PC with LV2011. The EXE folder is attached as ZIP. Regards Heinrich Eidloth

[Heinrich-Hans]

again with attachment

[Heinrich-Hans]

third try

[Heinrich-Hans]

next

[KurzVero]

Hello Mr. Eidloth,

Could you please try running the attached exe and let me know if it works properly?

Thank you very much.

Regards

[KurzVero]

I´m sorry. The file has to be converted from .txt  back to .exe because the transfer via zip does not work.

[Heinrich-Hans]

Hello Ms. Kurz, I just tested it on my virtual machine, and it woked as expected. Regards Heinrich Eidloth

[Hooovahh]

I don't have a solution (I'm sure NI is investigating) but I do have a work around.  Attached is a VI that I use to stop or Exit LabVIEW.  This is a very common feature and has been reproduced alot.  My version adds an optional Taskkill of the application.  Run this VI at the end of your application, after you are sure all clean up has finished, and all references have been closed.  Then wire a True to the Task Kill EXE terminal which is False by default.  Note that this taskkill only will be commanded if you are in a built application and not while running in source.

[KurzVero]

Hello Hooovahh,

thank you for posting the Workaround.

Hello Mr. Eidloth,

I will contiune looking into the case and hope I can get back to you soon with a solution.

Unfortunately I will be out of the office tomorrow and on Monday.

Please excuse the delay.

Regards