make a full wave rectifier using labview

[NainaSarda]

Hello!

I have been trying to acquire an accurate ECG signal using DAQ. After implementing noise removal methods like using filters, I'm getting ECG signal which has ALTERNATE CYCLES INVERTED.

I have attached the VI file and the screenshot of the output.

I will be grateful if anyone provides a solution to this problem.

Thank you.

[NainaSarda]

Hello!

I have been trying to acquire a real time ECG signal using DAQ. After implementing various noise removal methods like using a filter, I am getting an ECG signal having ALTERNATE INVERTED CYCLES.

I am attaching the VI file and the screenshot of the output. I will be grateful if anyone provides a solution to this problem.

Please! help!

Thank you.

[NainaSarda]

I am working on a project on aquiring ECG signals. I am getting the output with ALTERNATE INVERTED cycles. So I want to put a full wave rectifier at the output in order to get all the cycles. can you please help me with the solution how to do full wave rectification at the output?

[GerdW]

Hi Naina,

please keep your discussion in one place! We don't like to discuss the same problem in 3 threads in parallel…

[David-n-MO]

Signal can't be right.  It's unipolar 0 to 2.5V and clipping on both ends.  Too much signal.  If you disconnect or ground the input I'd expect it to go mid-scale at 1.25V.  So reduce the gain, subtract 1.25 from the data and then run it through your filter.

Good luck,

David