Insane Object Error

[Damill]

I get an Insane Object error. I have tried to remove newly created wires/tunnels and also tried to copy/paste the code into a new vi, with the same result. Does anyone have a suggestion how to resolve this?

Regards,

Roger

[becktho]

Hi Roger

Did you already search the forums? There are lots of threads about insane objects - these are just three of them:

http://forums.ni.com/ni/board/message?board.id=170&message.id=24302&query.id=417935#M24302

http://forums.ni.com/ni/board/message?board.id=170&message.id=209203&query.id=417949#M209203

http://forums.ni.com/ni/board/message?board.id=170&message.id=140714&query.id=417973#M140714

Thomas

[dan_u]

You don't happen to have a version control system? If so, check out the latest version without that problem and redo the changes.
Without that, I'd suggest copying the block diagram section by section in a new VI and saving the VI after each copy process.

Hope this helps,
Daniel

[Damill]

Thank you very much, everything is solved now. I found the wire causing this error!

Regards,

Roger

[wd8ivl]

Try this link....this always works for me.

http://forums.ni.com/ni/board/message?board.id=170&message.id=179722&query.id=21668#M179722

Mike